DAVIS Wireless Repeater 7625 Manual de Instalação descarregar pdf (Página 9)

Mounting the Wireless Temperature Station Page 9

3. Using an adjustable wrench or 7/16" wrench, tighten the nuts.

4. Place the second U-bolt around the pole and through the two holes at the bottom of

the shelter.

Put a ﬂat washer, a lock washer, and a hex nut on each bolt end, and tighten

the hex nuts.

Mounting on a Vertical Surface

1. With a 3/16" (5 mm) drill bit, drill two holes approximately 2" (50 mm) apart. Use a

carpenter’s level to ensure the holes will be level.

2. Drill two more holes 7-1/32" below the upper holes.

MOUNTING TEMPERATURE STATION ON A VERTICAL SURFACE

3. Insert the 1/4" x 1-1/2" lag screws through the ﬂat washers, and through the holes at

the top of the shelter into the post.

Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

4. Insert the 1/4" x 1-1/2" lag screws through the ﬂat washers, and through the holes at

the bottom of the shelter into the post.

Using an adjustable wrench or 7/16" wrench, tighten the lag screws.

Flat

Washer

Lag

Screw

Wireless Temp Page 9 Thursday, December 7, 2000 2:09 PM

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

DAVIS Wireless Repeater 7625 Manual de Instalação Página 9