DAVIS Wireless Temperature/Humidity Station Especificações

Product # 6380Wireless Temperature/Humidity Station Installation ManualFor Vantage Pro® or Vantage Pro Plus™The Wireless Temperature/Humidity Station,

10 MaintenanceMaintenance• The ability of the radiation shield to keep fresh air flowing over the sen-sors will be reduced if the shield plates become

A Note on Securing Cables 11A Note on Securing CablesTo prevent fraying or cutting of cables, secure them so they will not whip about in the wind. Sec

Product Numbers: 6380Davis Instruments Part Number: 7395.142 Wireless Temperature/Humidity Station Installation ManualRev B (May 14, 2003)This produc

2 Installation StepsInstallation StepsFor ease of installation, please follow the steps in the order presented. • Preparing the Temp/Hum Station, page

Preparing the Temp/Hum Station 35. Fasten the mounting bracket in place using the three long screws as shown in the illustration below.Applying Power1

4 Setting the Transmitter ID3. Verify that the temp/hum sensor cable is plugged into the receptacle labeled “TEMP HUM” on the SIM.4. Insert the 3-volt

Setting the Transmitter ID 5Use this table to ensure that each wireless transmitting station in your system is broadcasting on its own transmitter ID.

6 Setting the Transmitter IDSetting the Console Station ID using WeatherLinkYou can also set the console ID for your Temp/Hum Station from WeatherLink

Choosing a Location for the Temp/Hum Station 71. The DIP switches were not correctly set on the Temp/Hum Station. Review the procedure on page 4. 2. T

8 Mounting the Temp/Hum StationMounting the Temp/Hum StationThe Temp/Hum Station can be mounted on a pole or on a vertical surface such as a wooden po

Mounting the Temp/Hum Station 9Mounting on a Vertical Surface1. Using four 1/4" x 1-1/2" lag screws (not included), attach the mounting brac