Davis Vantage Vue Wireless Console Manual Manual do Utilizador descarregar pdf (Página 19)

Current Weather Mode

1. Press the + and - keys to select the baud

rate.

Your Vantage Vue console supports baud

rates of 1200, 2400, 4800, 9600, 14400,

and 19200.

2. Press DONE to save the baud rate settings.

Exiting Setup Mode

You have successfully completed all the screens in the Setup Mode. To exit Setup Mode, press

and hold DONE for several seconds until the Current Weather screen appears.

Clear All Command

After you have completed the above set up procedures and have exited the Setup Mode and

once the Vantage Vue ISS, Vantage Pro2 ISS or Anemometer Transmitter kit has been

installed, use the Clear All command before putting your weather station into service.

The Clear All command clears all stored high and low weather data including monthly and

yearly highs and lows, and clears the alarm settings. The command is recommended to

properly clear the console of any erroneous data when first putting your station into use.

1. Press WIND to display wind speed on the console.

2. Press 2ND, then press and hold CLEAR for at least six seconds.

3. Release CLEAR when you see “CLEARING NOW” displayed at the bottom of the

console’s screen.

Current Weather Mode

In the Current Weather Mode you can display the current data readings from your station,

select units of measure, and calibrate, set, or clear weather variables.

You can see up to eight weather

variables on the screen at the same time,

as well as the time and date, moon phase

and forecast icons, and a graph of the

currently selected variable.

Some variables are always visible on the

console screen while most variables

share their location with one or more

variables. You can select any variable

not currently on the screen to display it.

WIND

INSIDE OUTSIDE

RAIN RATE

CHILL

in/hr

F F

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Sem comentários

Davis Vantage Vue Wireless Console Manual Manual do Utilizador Página 19