DAVIS CarChip 8210 Guia do Utilizador descarregar pdf (Página 21)

To show braking events in the plots:

1. Choose Plots from the Setup menu. The Setup / Plots dialog box appears.

2. Click on the check box next to Draw Braking Events to toggle the function on and off. A check indicates

that the Draw Braking Events function has been enabled.

3. Choose OK to save the new plot setup. Choose Cancel to exit the dialog box and retain the previous

plot setup. Choose Apply to make the change without exiting the dialog box.

Note: You can call up the Plots setup dialog box and toggle the braking events on and off while viewing the

plots.

Draw Plots As Lines

You can configure the plots to use plain lines or to fill in the area under the plot line.

To select the type of plot lines:

1. Choose Plots from the Setup menu. The Setup / Plots dialog box appears.

2. Click on the check box next to Draw Plots Using Lines Rather Than Areas to toggle the function on and

off. A check indicates that a plain line will be used. If there is no check, the area under the plot line will

be filled.

3. Choose OK to save the new plot setup. Choose Cancel to exit the dialog box and retain the previous

plot setup. Choose Apply to make the change without exiting the dialog box.

Note: You can call up the Plots setup dialog box and toggle the plot line fill on and off while viewing the plots.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 60 61

Sem comentários

DAVIS CarChip 8210 Guia do Utilizador Página 21