DAVIS CarChip 8210 Guia do Utilizador descarregar pdf (Página 9)

2. Plug the CarChip data logger into the OBDII connector.

3. Check to make sure the data logger indicator light is blinking. This verifies CarChip was properly

inserted into the OBDII port and is communicating with your vehicle.

Installing CarChip Software

Follow the steps provided below to install the CarChip software. CarChip software is compatible with computers

running Windows™ 95, 98, ME, NT 4.0, 2000 or XP.

1. Place the CarChip software CD in your CD ROM drive.

2. The install program should start automatically. If the install program does not start, choose Run from the

Start menu, type D:\SETUP (or the correct letter for your CD ROM drive), and choose OK to begin the

installation.

3. Follow the on-screen prompts to complete the installation.

Connecting CarChip to a Computer

Following these instructions to connect the CarChip data logger to your computer:

Note: You may want to turn off your computer before connecting the CarChip download cable to prevent

damage to your computer.

1. Locate a free serial port on the back of your computer and insert the 9-pin connector of the download

cable into the port.

2. Plug the power adapter cable into the power jack on the 9-pin connector.

3. Plug the power supply into an AC outlet.

4. Plug the 8-pin microminiature connector into the port on the CarChip data logger.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 60 61

Sem comentários

DAVIS CarChip 8210 Guia do Utilizador Página 9