DAVIS Wireless Repeater 7625 Manual de Instalação

Product # 6330 A NEMOMETER T RANSMITTER K IT I NSTALLATION M ANUAL This manual describes how to install the Anemometer Transmitter Kit for W

Page 10TESTING TRANSMISSION FROM PROPOSED LOCATIONIt is very important to test reception from the proposed location before perma-nently mounting the a

Mounting the Anemometer Transmitter Page 113. Swivel the anemometer until the arm is pointing north.4. Using an adjustable wrench or 7/16" wrench

Page 12Mounting Transmitter Shelter on a Pole1. While holding the shelter against the pole, place a U-bolt around the pole and through the two holes o

Mounting the Anemometer Transmitter Page 13Mounting Transmitter Shelter on a Vertical Surface1. With a 3/16" (5 mm) drill bit, drill two holes ap

Page 14A NOTE ON SECURING CABLESTo prevent fraying or cutting of cables, secure them so they will not whip about in the wind. Secure a cable to a meta

Contacting Davis Instruments Page 15“The wind direction is stuck on north, or displays dashes.”It is likely that there is a short or break somewhere b

Product Numbers: 6330Davis Instruments Part Number: 7395.137 Anemometer Transmitter Kit Installation Manual Rev. A Manual (12/28/00)This product co

Page 2 T OOLS FOR S ETUP In addition to the kit, you will need some or all of the following materials: ✦ Adjustable wrench or 7/16" wrench ✦

Removing the Anemometer from its Current Location Page 3 R EMOVING THE A NEMOMETER FROM ITS C URRENT L OCATION This step assumes that your I

Page 4 If Your ISS is Mounted as a Single Unit (Both Sides Together on a Pole) Unfasten the anemometer: 1. Remove the black rain collector cone fro

Setting the Transmitter ID Page 5 5. Locate the DIP switches. You will work with them during the next installation step. S ENSOR I NTERFACE M ODUL

Page 6 The factory default transmitter ID is ‘1’. Looking at the table below, you can see that means the DIP switches are in the OFF position when ea

Setting the Transmitter ID Page 7 Setting Console/Receiver(s) to Same ID 1. Put your console into Setup Mode — press and hold the DONE key and press

Page 8 If You Do Not See Current Wind Readings First, verify that the console/receiver is powered and is not in Setup Mode (exit Setup Mode by pressi

Choosing a Location for the Anemometer Transmitter Page 9 C HOOSING A L OCATION FOR THE ANEMOMETER TRANSMITTERKeep the following factors in mind