Davis Sensor Tilting Bracket for GroWeather or EnviroMon Manual do Utilizador descarregar pdf (Página 2)

Page 2 Sensor Tilting Bracket

OOLS

AND

ATERIALS

EEDED

In addition to the components listed above, you will need some of the follow-

ing tools and materials. Please be sure you have everything you need before

beginning the installation.

✦

Solar Radiation and/or UV Sensor

You will also need the #6-32 x 1-1/2" (38 mm) machine screws, #6 wash-

ers, #6 screws retainers, and springs included with the sensor.

✦

Medium Phillips Screwdriver

✦

Wrench or Pliers

✦

Drill with 7/32" (.219", 5.5 mm) Drill Bit

✦

Cable Clips or Weather-Resistant Cable Ties with screw holes or other means for

mounting

SING

TANDOFFS

TTACH

ENSOR

Consult the sensor manual for instructions on attaching the sensor to the

STB. However, if mounting the sensor on the tilting bracket in a location

under 46˚ latitude or in a situation which requires the angle of the tilting

bracket to be less than 28˚, you will need to use the standoffs supplied with

the tilting bracket as shown below. (The standoffs allow enough room

between the bottom of the sensor and the SMA.) The standoffs are made of

aluminum; take care not to overtighten when screwing into the bracket.

Consult the sensor manual for the remaining instructions on attaching the

sensor to the STB.

SING

TANDOFFS

OUNT

THE

ENSOR

1 2 3 4 5 6 7 8

Sem comentários

Davis Sensor Tilting Bracket for GroWeather or EnviroMon Manual do Utilizador Página 2