Davis Sensor Tilting Bracket for GroWeather or EnviroMon Manual do Utilizador descarregar pdf (Página 7)

Mounting the Sensor Tilting Bracket Page 7

3. Attach the STB to the surface as shown below using the #8-32 screws, #8 washers,

#8 lock washers, and #8-32 hex nuts. See “The Tilt Angle” on page 3 to determine

which hole to use on the arms.

Make sure you place three #8 washers between the arms and the mounting

surface. For clarity, the sensor is not shown in the drawing below.

OUNTING

LTERNATE

URFACE

4. Secure the sensor cable to the mounting surface using cable clips or weather resistant

cable ties with screw holes or other means for mounting.

ECURING

ENSOR

ABLE

1 2 3 4 5 6 7 8

Sem comentários

Davis Sensor Tilting Bracket for GroWeather or EnviroMon Manual do Utilizador Página 7