Davis Universal Anemometer Interface for Vantage Pro2 Manual do Utilizador descarregar pdf (Página 6)

Insert the Battery

1. Insertthe3‐voltlithiumbatteryintothebatteryholder,matchingthe“+”sign

onthebatterywiththe“+”signinsidetheinterfaceshelter.

Note: It will take approximately one minute for the capacitor to charge and the unit to begin functioning.

Connect the Cable to the New Anemometer

R. M. Young 05103:

1. Openthejunctionboxontheanemometerandcutthejumperwire.(Its

locationismarked“JUMPFORCOMMONREF”.)

2. Unscrewthesealingnutonthestrainrelief.

3. Oneendofthe6‐connectorcablehasfivecoloredwires,tinnedandstripped,

andawhite(unused)wire.Feedthisendofthecablethroughthesealingnut

andthestrainreliefintothejunctionbox.

4. Connectthewirestothenumberedterminalstripasfollows:

Black . . . . . . .2

Red . . . . . . . . .3

Green . . . . . . .4 

Yellow . . . . . .5

Blue . . . . . . . .6

White . . . . . . .unused

5. Replacethejunctionboxcoverandsealingnut.



NRG#40C/MAX40:

1. Useonlytheblackandbluewires.Connecttheblackwiretothe

anemometer’sblackgroundwireandthebluewiretotheanemometer’s

whitesignalwire.

2. Connecttheredandgreenwirestogether.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Davis Universal Anemometer Interface for Vantage Pro2 Manual do Utilizador Página 6