DAVIS Sensor Mounting Arm Manual do Utilizador

Product # 7702 S ENSOR M OUNTING A RM The Sensor Mounting Arm provides an ideal mounting location for all of your Davis weather station sensors. Th

Page 10 Sensor Mounting Arm 7. Position the U-bolts/saddles on top of the sensor arm on the side farthest from the mounting bracket so the ends of th

Attaching the Anemometer Page 1110. Slide the anemometer arm backwards/forwards until the end of the anemometer arm extends just 1/2” past the second

Page 12 Sensor Mounting Arm15. Secure the cable clamp and cable in place using an #8 flat washer and an #8-32 hex nut.Tighten the hex nut until the cab

Mounting the Sensor Mounting Arm Page 13Mounting the Sensor Mounting Arm on a Small PipeFollow the instructions below to mount the Sensor Mounting Arm

Page 14 Sensor Mounting ArmMounting the Sensor Mounting Arm on a Large PipeFollow the instructions below to mount the Sensor Mounting Arm on a pipe wi

Grounding the Sensor Mounting Arm Page 15GROUNDING THE SENSOR MOUNTING ARMWe strongly recommend that you ground the sensor arm. You will need the 16.5

Product Number: 7702Davis Instruments Part Number: 7395-091Sensor Mounting ArmRev. C Manual (7/7/99)DI:Weather:Accessories:Sensor Mounting ArmThis pro

Page 2 Sensor Mounting Arm n. Two 1/2” U-Bolts (for anemometer arm) o. Two 1/2” Saddles p. Two 1-1/2” U-Bolts (for pipe with outside diameter between

Assembling the Sensor Mounting Arm Page 3 The Sensor Arm The illustration below shows the sensor arm and indicates which holes are used by the variou

Page 4 Sensor Mounting Arm A TTACHING THE M OUNTING B RACKET In order to attach the mounting bracket to the sensor arm, you will need the sensor

Attaching the Anemometer Page 5 A TTACHING THE A NEMOMETER You may mount the anemometer on either side of the sensor arm. The pre-ferred mounting

Page 6 Sensor Mounting Arm Attaching the Anemometer Below the Sensor Arm (Preferred) To attach the anemometer below the sensor arm, you will need the

Attaching the Anemometer Page 7 6. Slide the ends of the U-bolts into the appropriate holes at the end of the sensor arm nearest the mounting bracket

Page 8 Sensor Mounting Arm 8. Slide the anemometer arm backwards/forwards until the end of the anemometer arm extends just 1/2” (13 mm) past the sec

Attaching the Anemometer Page 9 Attaching the Anemometer Above the Radiation Shield To attach the anemometer above the sensor arm, you will need the