DAVIS Sensor Mounting Arm Manual do Utilizador descarregar pdf (Página 4)

Page 4 Sensor Mounting Arm

A

TTACHING

THE

M

OUNTING

B

RACKET

In order to attach the mounting bracket to the sensor arm, you will need the

sensor arm, mounting bracket, two #8-32 x 2-1/2” screws, four #8 ﬂat washers,

two #8 split lock washers, and two #8-32 hex nuts.

1. Place one #8 ﬂat washer over the end of each of the #8-32 x 2-1/2” screws.

2. Position the mounting bracket so the holes in the mounting bracket line up with the

appropriate holes on the sensor arm.

3. Slide each of the #8-32 x 2-1/2” screws (with washer) through the holes on the sensor

arm and the mounting bracket.

4. Secure the mounting bracket to the sensor arm using a #8 ﬂat washer, #8 split lock

washer, and a #8-32 hex nut on each screw end.

Tighten until the mounting bracket is securely fastened to the sensor arm.

A

TTACHING

THE

M

OUNTING

B

RACKET

1 2 3 4 5 6 7 8 9 ... 15 16

Comentários a estes Manuais

Sem comentários